HONRICH Wireless Car Charger, 10W Fast Charging Auto-Clamping Mount, Air Vent Car Phone Holder Compatible with iPhone…

$6.47

【Intelligent fully automatic induction】The SYJ-H006 is a very convenient wireless car charger, using the infrared induction structure design. The clips at two side will open and close automatically when the phone is approaching. And the phone begins charging after it has been clamped and locked after short delay automatically. If you want to take out your phone from it, please click the touch switch on the bottom or right side to release, take the phone out.
【Constant frequency fast charging】10W/7.5W fast charging. Can support all Qi standard phone charging technology. Compatible with 5V/9V dual charging mode. Constant frequency wireless fast car charging is more stable. Four points around phone and stable clamp what make phone not move. No afraid of bumpy road conditions and emergency braking and acceleration. Stable charging to protect your phone.
【Simple installation and Use】 Put the anti-slip silicone mat into the back side of the charging, twist the clip slightly, tighten the air vent clip into the charger. Install to the air vent, adjust to the right angle and plug the type-c USB charging cable, then put the phone to charger. It also can be used as a phone holder for your car life.

More Specifications:

Technical Specifications:
Model: SYJ-H006
Standard: GB 4943.1-2011
Conversion Rate: 85% (Max)
Input: 5V2A / 9V1.67A
Output: 5V1A / 9V1.1A
Dimen sion: 130*97mm

Notes:
1.Use a qualified USB power adapter (5V-2A), otherwise the charge may be unstable.
2. Do not put metal debris or magnetic card on the charging plate, which may cause damage or the charger does not work.
3. If the receiving coil or plate overheated during use, stop charging. Please remove the charging product, after cooling, try charging again.

Safety Advice:
Do not pull the power cord hard, to avoid power cord breakage or fall off.
Do not remove or put H006 into the fire, water, to avoid short circuit leakage.
Do not use H006 in severe high temperature, wet or decayed environments to aviod leakage or electricity or weakening of magnetic force in damaged circuits.

FAQ and Solution:
1. Why it charges slowly than my original adapter came with the mobile device?
The phone (receiver built-in) or external receiver coll allows the wireless charging current is different, or the phone standby power consumption is large while charging, suggest to reduce standby application.
2. Why the led indicator keep flashing and my phone does not receive any charge?
Please make sure your mobile device is QI-Standard supported. Make sure you find the right charging position. Make sure you use an AC adapter with full 2A output.
3. My device is hot while charging, is it normal?
It depends on the receiver in your phone. If the charging coil of the receiver in your hone is small, the heat dissipation may be not good and it will cause your phone hot during charging.
4. Host light is normal, the phone can not work.
The charging position is not aligned when there is problem with the cell phone receiving ring. It is recommended to replace the receiving ring or repair phone.

【Intelligent fully automatic induction】The SYJ-H006 is a very convenient wireless car charger, using the infrared induction structure design. The clips at two side will open and close automatically when the phone is approaching. And the phone begins charging after it has been clamped and locked after short delay automatically. If you want to take out your phone from it, please click the touch switch on the bottom or right side to release, take the phone out.
【Constant frequency fast charging】10W/7.5W fast charging. Can support all Qi standard phone charging technology. Compatible with 5V/9V dual charging mode. Constant frequency wireless fast car charging is more stable. Four points around phone and stable clamp what make phone not move. No afraid of bumpy road conditions and emergency braking and acceleration. Stable charging to protect your phone.
【Simple installation and Use】 Put the anti-slip silicone mat into the back side of the charging, twist the clip slightly, tighten the air vent clip into the charger. Install to the air vent, adjust to the right angle and plug the type-c USB charging cable, then put the phone to charger. It also can be used as a phone holder for your car life.
【Safe charging and Apply to Iphone/Android】 The wireless car charger quoted temperature control technology chip, charging at low temperature and don’t burn. It can protect phone’s battery life. 7.5W fast charger for iphone 11 Pro Max/11 Pro/11/Xs Max/XS/X/8 Plus/8, 10W fast charger for Samgung S10/S10+/S9/S9+/S8/S8+, Note 10/9/8 and 5W fast charger for others Qi phones. It also can charger with phone case.
【After-safes Guide and Service】You can get 1 × Qi wireless car charger, 1 × Air Vent Clip, 1 x Type C Cable (length 1M), 1 x User Manual. We provide 1 year guarantee to ensure the quality of our product. If you have any problem with this wireless charger, please contact us via the customer service email, we will reply you within one day.

Package Dimensions

Item Weight

Other display features

Colour

Manufacturer

Date First Available
Brand

,

Reviews

There are no reviews yet.

Be the first to review “HONRICH Wireless Car Charger, 10W Fast Charging Auto-Clamping Mount, Air Vent Car Phone Holder Compatible with iPhone…”

Your email address will not be published.

Skip to content